RC 3D Printing Forum: Cars, Chassis & More

Welcome to the Model FACTORY / mfactory33 – COMMUNITY!Compact RC Cars/Trucks (1 CHASSIS built for 1 BODY): Ford F-150 BAJA (Trophy Truck)Servo motor mount

You need to log in to create posts and topics.

Servo motor mount

#1 · March 27, 2026, 3:26 pm

Im pretty far into assembly and durring the step when i attach the servo it didnt fit in.
Had to sand down some material on the small edges where it sits, the back side and also the bottom of the servo motor. Extra 30 minutes of work.
Perhaps the left side of the square hole can be extended about 2-3mm

Uploaded files:

#2 · March 28, 2026, 11:35 am

Hey,

You chose a slightly larger servo than the one we used: Feetech FS5103B (40.8 × 20.1 × 38 mm).

I used three different servos in this size range, and all of them had very similar dimensions.

Best regards,

Balázs

#3 · April 1, 2026, 9:25 pm

Thanks for the reply, but I still suggest looking into extending the end part a little bit more if that doesnt reduce integrity of the part too much since I bought another servo and it too did not fit, even more than the first.